Carpet stair runner – Installing carpet runners on stairs will make your home appear more elegant and make the trip up and down the stairs more comfortable. How to install carpet stair runner? First, cut a strip tackles for each tread of the stairs you want the carpet. Cut tackles strips an inch shorter than the width of each step or slightly shorter than the width of the mat. You will put on your staircase. Second, attach tackles strips each step about a half inch above the point where each tread face each strain. Attach using a half inch staple gun or use half inch nails.
Be sure you measure carefully to ensure that tackles strip centered exactly on every step. Using a utility knife, carefully cut carpet padding bits is the width of the tack strips. They should hang about two inches above the nose of each step. Place a rug pad on each step and staple down safely. Fourth, secure the runner to the staircase that starts at the lowest step and work your way up. Start by lining up the perfect square end of carpet stair runner with the lower edge of the first riser where it meets the floor. Using the staple gun to staple the stair runners to the riser as close to the floor as possible, staple every two inches.
Pull the mat up tightly and staple just below the edge of the nose. Fifth, pull the carpet tightly over the first step and attach the carpet to tackles strip near the path of the first step. Make sure you have stretched the carpet straight. When you are satisfied, use the staple gun to staple the carpet to the steps right at the transition between the tread and the riser. Pull the mat up tightly and staple under the nose of the next tread and then continue the process to the top of the stairs. And the carpet stair runner installation was done.